Dreampod Vmax Float Pod - Commercial XL Sensory Deprivation Tank

The Vmax is Dreampod's extra-large commercial float pod and differs from the V2 and Sport in three key ways. First, the interior: at 7'10" × 5'4", the Vmax is large enough for two adults to float simultaneously — neither the V2 nor the Sport offers that capacity. Second, the Vmax includes dual chemical injection, a sanitation system that delivers two disinfectants simultaneously through the filtration cycle. The V2 also includes dual chemical injection; the Sport uses UV with a single chemical dispenser. Third, the Vmax uses a larger magnetic drive pump motor, which handles the higher salt water volume of the bigger shell to keep cleaning time between floats to a minimum. Both the Vmax and V2 include TCP/IP web control; the Sport uses a wall panel only.

Yes. The 7'10" × 5'4" interior was designed with couple floating as one of its primary commercial use cases. Two adults can float side by side without touching. Most commercial operators who offer couple floats price them at 1.5 to 2 times the single-float rate — the same pod, the same session slot, significantly higher revenue. Among the Sport, V2 and Vmax, the Vmax is the one large enough to offer this service tier.

For context: the pod holds over 450 kg of dissolved Epsom salt. The salt-saturated water is so dense that both floaters are fully supported at the surface simultaneously, with no swimming or effort required.

Electrical: the Dreampod Vmax requires a dedicated 220V / 60Hz / 15A circuit with a GFCI breaker. This is a 240-volt line — the same type used for electric dryers and ovens. It cannot run on a standard 120V household outlet. Your electrician should run this circuit before the pod arrives.

Plumbing: the Vmax does not require a floor drain or plumbing connection for normal operation. The salt water stays in the pod. You will need a garden hose connection for initial fill (filling and dissolving the salt takes several hours) and access to a drain for the rare full water change. Dreampod provides a fill and drain protocol in the installation guide.

Space: minimum 10' × 14' floor footprint with 7'+ ceiling clearance. The pod itself is 8'6" × 5'8" — allow adequate clearance on three sides for access and maintenance, and extra clearance at the door end for filtration unit access — Dreampod's installation guide specifies exact clearance requirements for your room layout.

Two separate dosing lines connect to the filtration circuit, each delivering a different disinfectant simultaneously during the filtration cycle — no manual mixing or separate dosing steps between sessions. Operators can run any approved two-chemical sanitation protocol (hydrogen peroxide + oxidizer, or any combination approved for commercial float tank operation in their jurisdiction).

Injection cycles are tracked automatically through the TCP/IP panel. The result: fewer manual interventions per day, more consistent water chemistry, and a sanitation log maintained automatically rather than by hand.

The Vmax connects to your local network via a CAT5 ethernet cable. Access the control panel from any web browser on the same network — laptop, desktop, iPhone, or iPad. No app download. No account creation. From the panel you can: start/stop filtration, adjust water temperature, program LED lighting, manage audio playlists, and view session logs for maintenance tracking.

Multi-pod operators assign each Vmax its own IP address and manage all units from one browser screen — no trips into the float room between clients. Note: TCP/IP is a local-network system only. It does not work over cellular unless your device is on the same network as the pod.

The Dreampod Vmax ships in three parts (base, lid and back piece) with a separate engine box. The base fits through a standard doorway, and hallways and 90-degree corners need at least 1,400mm (4.5 ft) of width. Installation: move the parts into your prepared room with an adequately staffed team, connect the 220V circuit and CAT5 ethernet, fill with water, and dissolve the Epsom salt. Dreampod recommends hot water to accelerate dissolution. Most installs finish mechanical setup in one day, salt overnight, first sessions the following morning.

In-stock pods ship within 48 hours of payment, and shipping usually takes 5 to 8 days. When the Vmax is on pre-order, the expected date is shown near the price. Have your 220V circuit, CAT5 ethernet, and 700 kg of Epsom salt ready before delivery day.

The Dreampod Vmax carries Dreampod’s limited warranty: 2 years on fiberglass construction and 1 year on electronic and mechanical components (pump, filtration system and computer systems), from the date of retail purchase.

As an authorized Dreampod dealer, Recovery Room Direct can coordinate warranty service on your behalf.

Yes. Recovery Room Direct is a factory-authorized Dreampod dealer. Every Dreampod Vmax purchased through our store carries the Dreampod manufacturer warranty, which runs from the date of retail purchase.

Purchasing a Dreampod pod from an unauthorized reseller can result in a voided manufacturer's warranty and limited access to Dreampod's service network. Our authorized status means we have a direct line to Dreampod for warranty escalation, parts orders, technical questions, and installation support.

Have questions before you order? Call us at (888) 500-5675. Our team has hands-on familiarity with the Vmax and can walk you through room requirements, electrical prep, salt sourcing, and any operational questions specific to your facility.

Current pricing is shown live on this product page — scroll up or click Add to Cart to see the price and select your finish (White or Stealth Black). Pricing can change, so the number shown at checkout is always the most accurate.

For commercial buyers ordering multiple units, or if you have questions about volume pricing, financing options, or total project cost including installation and salt, call us directly at (888) 500-5675. We work through the full cost picture with commercial operators before they order. Shop Pay Installments financing is available at checkout for qualified buyers.

Check water pH and sanitizer levels at least twice per week (daily for commercial operations). Target pH: 7.2–7.8. The dual chemical injection system doses automatically during filtration cycles — monitor to confirm the system is dosing correctly. Replace the 10-micron bag filter every 30–90 days depending on session volume. Replacement bags available through Recovery Room Direct — (888) 500-5675.

Full water changes are rarely needed. Most commercial float tank operators change the full volume every 6–12 months, or per local health department requirements.